|
Instructions:
1. Cut the length of thread you wish your necklace to be. You may choose to double the thread for extra stability if you like. In that case, use a thread that is a bit thinner.
2. Take a 4mm round bead and insert two ends into the hole and pull the bead to the center. Gather the ends together and now insert them through the large pendant. The round bead prevents the pendant from falling off. (See picture 1 above)
3. Add now both ends through two faceted beads. (See picture 1 above)
4. Now you will be working on each end individually. Start with adding a crimping bead to one side about 3 cm or 1.2 inches from the two beads. Now insert a faceted bead on the thread. (See picture 2 above) The crimping bead will prevent the faceted bead from sliding all the way down. Add the next crimping bead 3 cm above the last crimping bead and then add the next faceted bead. Continue in this manner unter you have used up all 6 (+ -) beads on one side.
5. Repeat step 4 for the other side.
6. Add your closure as described in the technique in this link:
How to Start and Finish off a Necklace or Bracelet
This is an easy technique.
Jewelry Beads
Use this page as a reference. These are a selection of beads used on the jewelry projects found on this site.
Jewelry Findings
Use this page as a reference when you are unsure about a particular item mentioned in the jewelry projects.
How to make a wire loop for jewelry crafts
Next Craft >>> Beaded Ring for Kids
|
More Crafts for Summer