|
For this project you will need:
- blank artist trading card
- scrap piece of soft olive green scrapbook
paper
- 1 cm strips of textured green cardstock -
here the “Fall Cardstock Stack” from DCVW
was used
- paper punches - leaf stem, retro flower and
tag punches were used
- olive green fiber paper
- olive green cardstock
- 2 small olive green brads
- 1 jumbo olive green brad
- olive green netting ribbon
- gold eyelet
- hole puncher
- stick glue
- double sided adhesive (transparent)
|
|
|
Instructions:
When adding each new type of paper or paper, lay paper over the card, adhere and trim excess paper away from the edges if necessary.
1. Adhere the light green scrapbook paper onto the card.
2. Glue one strip of textured cardstock down the left side of the card about 1 cm from the edge. Now adhere 3 more strips across the card. Two strips at the top and one strip at the bottom.
3. Use transparent double sided adhesive and adhere a strip of netting down the left side of the card over the 1 cm cardstock strip.
4. Tear a small piece of green fiber paper and glue it to the card.
4. Punch out leaf stems and stick them randomly on the card. See picture.
5. Poke a hole on the right top and right bottom of the card and secure the brads through these holes.
6. Create a small tag. Stick a strip of 1 cm wide textured cardstock across the center. Now punch a flower out of the textured cardstock. Poke a hole through both the flower and the tag and insert the brad to secure flower.
7. Punch a hole at the top of the tag and insert the eyelet according to instructions. Tie a piece of green netting through the hole.
|
|
