|
For this project you will need:
- 1 blank white card with matching envelope
- white, navy blue and beige cardstock
- small motif punches with fish and seahorse
- double sided adhesive tape
- 3-D foam tape
- silver sticker with message
- 3-D card punchouts with
maritime bear motifs or motifs of your choice
|
|
|
Instructions:
1. Cut each whole bear motif out once and cut an additional bear dress and bear top with pants out. On the backsides of the clothing, place many pieces of 3-D foam pieces. Lay aside for the moment.
2. Cut out two 5cm x 6cm (2 inches x 2.4 inches) white pieces of cardstock out.
3. Adhere both white blocks each on beige cardstock and cut each now out with a 0.5 mm border (about 1/5 inch) on all sides.
4. Adhere now the blocks onto navy blue cardstock and cut each out with a 0.25 mm border (about 1/10 inch) on all sides.
5. Adhere a bear on each block. Remove the protective paper of the 3-D foam tape and adhere a second layer of clothing onto the bears. Lay the blocks aside for the moment.
6. Cut a navy blue strip measuring the width of your card and 7 cm (2.8 inches) high. Adhere the strip longways across the card.
7. Cut a small strip of navy blue cardstock large enough to hold your message and stick message on. Add a piece of 3-D foam tape to the backside of the strip.
8. Punch out small fish and seahorse and add small 3-D foam tape pieces on the backside of each.
8. Adhere now the blocks onto the card as seen in the picture and attach the other elements.
|
|
