|
Instructions:
1. Cut out an assortment of fabric squares each measuring 5 x 5 cm and proceed by taking the first piece and placing it over the wreath. Use the stylus and insert it in the center of the fabric and poke the fabric into the wreath. The styrofoam will normally hold the fabric without glue but you may rub on a thin coat of glue on the surface of the wreath if you like.
2. Continue adding new scrap pieces close to the previously added piece and continue in the same manner as step one until the entire front, inside and outside of the wreath is full. If you missed a section, you can always add more scraps afterwards.
|
