|
For this project you will need:
- Blank dark green card
- matching green inlet
- greet netting material or ribbon
- craft knife
- wooden golden star
- gold gel pen
- vellum with printed wish
- 3-D pads
- tape
- hole puncher
- 2 brass fasteners
|
|
|
Instructions:
1. Using the picture as a guide, cut 2 stars out of your card. Make 1 star larger than the other. Keep the cut out larger star for further use.
2. Use the gel pen and draw a line around the borders of the singly cut out star and around the 2 stars on the card.
3. Cut a piece of netting out that is the same width and length of the card and stick it to the back of the front side of the card.
4. Use 3-D Pads to adhere the larger star onto the card. Use the picture for placement guide.
5. Stick 2 - 3D Pads on the back side of the gold star and stick it to the card.
6. Cut a piece of vellum out with the greeting written on it. Punch 2 holes on either side of the vellum and through the front of the card. Place the brass fasteners through the holes to secure the vellum and fold them down on the backside of the front of the card.
7. Secure inlet on the inside of the card to cover up the netting.
|
|
