|
1. Add a crimping bed to the end wires of your finished piece of jewelry.
|
|
2. Now, add a jump ring to the wire and take the wire ends and go now through the crimping bead again. Pull the jump loop to the point where you would like it to be.
|
|
3. Use the pliers and squeeze the crimp bead flat.
|
|
4. This is how it looks now. Snip the excess hanging wires away.
|
|
5. Add the fastener to the jump ring and use the pliers to close the ring if necessary.
|
|
6. Repeat the steps for the other side and you can already wear your new jewelry piece!
|