|
Instructions:
1. Cut out a stack of fabric squares and proceed by taking the first piece and placing it over the wreath. Use the stylus, flat screwdriver or knitting needle and insert it in the center of the fabric and poke the fabric into the wreath. The styrofoam will normally hold the fabric without glue.
2. Continue adding new scrap pieces close to the previously added piece and continue in the same manner as step one until the entire front, inside and outside of the wreath is full. If you missed a section, you can always add more scraps afterwards.
3. Create a bow using the ribbon and adhere to the wreath.
|
